1994 DUTCHMAN TENT TRAILER

Discussion in 'Slide-Outs / Bunkends' started by wbrooks, Mar 13, 2011.

  1. wbrooks

    wbrooks New Member

    1
    0
    Mar 13, 2011
    I'm having trouble figuring out how to brase the two bed to the frame. This dutchman is not like my old coleman. A drawing would really help.
     
  2. Beerlifter

    Beerlifter Oklahoma, It's not just for Indians anymore!

    879
    0
    Jun 22, 2006
    Oklahoma City , Oklahoma
    Front Bunk End:

    The bed at the tongue of the trailer mounts to the body of the camper. Before you slide the bed out look at the top edge of the camper body (this is of course with the roof raised.) there should be two holes to put the pins of the bed support poles in. The poles should have hinged poles attached and the opposite end will fit into slots on the trailer frame. The bed then slides out on top of these poles.


    Rear Bunk End:

    The other bunk end supports will connect to the bottom side of the bed and to the bumper
     
  3. DarthMuffin

    DarthMuffin New Member

    206
    0
    Sep 16, 2010
    Like Beerlifter said, but the front bunk end on ours has two sets of poles (maybe this is just on the models with a King bed?). The ones mentioned, and a second set that goes from the tabs under the bed to the slots just behind the trailer coupler. The shorter pair of poles goes to the bigger (front) bed. Longer poles to the smaller (rear) bed.

    The poles are in the rear bumper if you haven't found them yet :)

    I find it easiest to crouch under the bunk and "put my back into it" to raise the bunk enough to get the slack required to get the poles into the slots.

    This may help:
    [​IMG]
     

Share This Page