Recent content by MileHigh

As long as your Pacifica allows a WDH, this one would work: https://www.huskytow.com/husky-towing-31995-weight-distribution-hitch

From the NPS site: https://www.nps.gov/yell/planyourvisit/flood-recovery.htm It is unlikely that Indian Peak or Madison will open at all this year. There is a lot to see in the Cody area and the East entrance is supposed to open on 6/22. I'd keep all your reservations but book backup spots...

Plan at this point is the East entrance but could change to the South if needed. Yes - video of Lamar should be interesting and I'm expecting some road damage. https://www.nps.gov/yell/learn/news/220613.htm

I have reservations to stay at Grant Village for 6 nights in late August and then Colter Bay for another 3. Based on the superintendent's media update yesterday, I'm going to keep the reservations for now. Though I had several back country hikes planned in the North loop, there is still...

Went from a popup to a travel trailer last year and never looked back. In my opinion, the positives out weight the negatives for many of the reasons already listed.

I believe that I have 2 of the pads and would be glad to give them to you. I'm in the Broomfield area...

And to think I've always found a rock that was the right size. Great idea...

Was at Devils Canyon on Friday, May 20th for the night. We were at #23. I had half a tank of fresh water along with a 7 gallon jug so I was OK. It's a nice place for sure.

Got back this past weekend from an 8-day to Utah and Arizona. First night was at Sam Stowe Campground (#6) at Fremont Indian State Park. This is a nice campground that has full hookups and we enjoyed it. Only issue as that we had a "squatter" in our reserved spot who didn't want to move! The...

I would probably add some 12 volt computer fans to the top vent if doing that. I'd be a bit concerned about enough airflow to cool effectively.

This may help also: https://www.cartechbooks.com/blogs/techtips/battery

You should have a Goshen lift system on your Rockwood. There is a pulley at the rear of the PUP that you can adjust to make it lift evenly. Here is a link to Goshen's site and a diagram: https://www.goshenstamping.com/lift-system

You definitely have some sag going on. It could be from a leak ...

I would try and build some type of wind block if you could. I've seen some people put a cheap furnace filter behind the vent. It will block the wind but still allow air flow.

Have you checked Etrailer yet? https://www.etrailer.com/dept-pg-Trailer_Jack-sf-A~Frame_Jack.aspx