Good evening all...I am new to the site though I have been researching prior to become by a member. All the insight has been great. I have recently been gifted a 94 Coleman Fleetwood Chesapeake CP. The PU was a welcomed gift. After inspection it was necessary to remove all of the canvas, canvas-brackets, lights, roof molding, etc. due to water intrusion. I have R&R and upgraded the structural and installed the side Luan board and foam insulation back. I am now ready to install the top canvas brackets. I DID NOT TAKE MEASUREMENTS PRIOR TO DEMO!!! I am in great need of a measurement for the following: 1. between the bottom of the top canvas bracket and the roof seal moulding. I need this measurement for the front/rear and sides. 2. Between the top of the stow away door bracket and the ceiling. Thank you in advance for anyone that can try and help out. I cannot get a quality measurement based off of pictures. Ideas are welcome.