Outward bow on back side

Discussion in 'Roof/Floor Repair & Maintenance' started by Jyssica, Apr 6, 2021.

  1. Jyssica

    Jyssica New Member

    Messages:
    20
    Likes Received:
    3
    Joined:
    Aug 3, 2020
    Please help, I'm about to throw in the towel. I have spent months rebuilding this roof with my dad. We put it on and the back side bows outward leaving a gap big enough that I cam fit my hand between the roof and the base of the camper. Obviously not water tight. Please tell me there is a fix. I'm about to take it off and just take a rubber mallet to try to get in place. We measured so many times during our build to make sure it was within the width we needed. I'm at a loss. The front side sits flush and perfect. It was my childhood pup that had ice load and the roof failed so it was a total gut and rebuild.
     

    Attached Files:

  2. Sjm9911

    Sjm9911 Well-Known Member Gold Supporting Member

    Messages:
    8,805
    Likes Received:
    6,207
    Joined:
    May 31, 2018
    Location:
    Nj
    What did you rebuild it with?
     

Share This Page